Lattice & Victorian Fence Top Accents
Found below are detailed instructions on how to install both the Lattice and Victorian fence top accents which can be attached onto many different styles of residential vinyl privacy fence including Chesterfield, Columbia, Galveston and Norfolk styles.
Once the main fence section is installed, proceed as follows:
Lattice
- Measure distance between inside faces of the posts
- Cut bottom channel to fit between posts
- Fasten bottom channel to top fence rail with (5) #8 X
1-1/2" screws evenly spaced along the length
- Insert lattice panel in channel
- Insert top channel over lattice
- Insert both ends of top channel into routed post holes
- Secure top channel in position with #8 x 3/4" screws
from inside post
- Fasten lattice to both channels with (6) #8 x 3/4"
screws, washers and snap caps spaced along channel (connect
to the same lattice strip on top and bottom)
|
Victorian
- Measure distance between inside faces of posts
- Center and cut bottom channel to fit between posts to
maintain even picket spacing
- Fasten bottom accent rail to top fence rail with (5) #8
X 1-1/2" screws inserted through picket holes
- Insert pickets in bottom rail
- Insert top rail over pickets
- Insert both ends of top rail into routed post holes
- Secure top rail in position with #8 x 3/4" screws
from inside the post
|
NOTE: Accents can be added to the following
styles:
Chesterfield
Columbia
Galveston
Norfolk I
SHOWN WITH CHESTERFIELD FENCE
| VICTORIAN ACCENT |
LATTICE ACCENT |
 |
|